The nose cone avionics arrangement went through quite a few iterations as it was more or less designed around the 4000mAh battery. However it proved to be quite a challenge mounting the battery on the centerline of the rocket / nose cone and still being able to fit the other components. Although the 86mm 5:1
A 3D printer camera shroud for the Mobius Mini was ordered from Additive Aerospace. However upon closer inspection I noticed the design could be optimized a bit for the GIGA rocket being: The Additive Aerospace camera shroud used four screws positioned in a square to secure the shroud to the airframe. This is particularly hard to
Pull pin Consisting of two-piece pin where as one part can remain in the rocket during preparations and a second part containing the “remove before flight” tag can be screwed on/off during assembly. With the Intimidator 5 we noticed that a protruding pull pin, especially in combination with parts / coupler pieces which need to slide into each other,